Date
1 - 6 of 6
genoa furler cover MEJ1 removal
Hi all Amel owners. i am struggling to remove the cover of the MEJ1 furler, to be able to replace te belt.
i have tried a rubber hammer, i do not like to use a srewdriver as this would damage the anodising of the cover and sealbed. Is the cover flat ? or has the furlerbody recesses for the screws? in other words does it have to come out vertically, or should i use more force with the hammer sideways? advice welcome. Jeroen Jeltes, Fidelis Am54 Aruba.
|
|||||||||||
|
|||||||||||
Roque
Hi Maybe this pic will help. Roque Attika A54 #117 Em qua, 20 de mai de 2020 às 12:43, Jeroen jeltes <j.jeltes@...> escreveu:
Hi all Amel owners. i am struggling to remove the cover of the MEJ1 furler, to be able to replace te belt.
|
|||||||||||
|
|||||||||||
Dear Roque, thank you for picture,it helps, pls do you have a picture of the cover? it is not clear if it has a flat surface. regards, Jeroen
|
|||||||||||
|
|||||||||||
i managed to get it removed finally, and apparently the cover is mounted in a recess.
|
|||||||||||
|
|||||||||||
Roque
Great! Maybe you could take this opportunity to install grease ports Em qua., 20 de mai. de 2020 às 14:59, Jeroen jeltes <j.jeltes@...> escreveu:
i managed to get it removed finally, and apparently the cover is mounted in a recess.
|
|||||||||||
|
|||||||||||
Maybe this helps...it is a page from my Amel Book. You did not state your hull number, but if it is an early 54 the cover is sealed with sealant and it may be a little difficult to remove:
On Wed, May 20, 2020 at 1:07 PM Roque <ediroque@...> wrote:
|
|||||||||||
|