Topics

SM Hawse pipe

Danny and Yvonne SIMMS
 

Hi all.

I have arrived where all us SM oweners will some time and am replacing the hawse pipe from the deck through the port deck locker. The old mild steel on didnt look too bad till  I hit it with a hammer and all the rust fell off. See the attached photo of the old pipe and my new stainless pipe ready to be glassed in.

Danny

SM 299

Ocean Pearl

Germain Jean-Pierre
 

Hi Danny,

Your hammer is very creative.

:-)

Jean-Pierre Germain, SY Eleuthera, SM 007


On 24 Jun 2020, at 14:10, Danny and Yvonne SIMMS <simms@...> wrote:



Hi all.

I have arrived where all us SM oweners will some time and am replacing the hawse pipe from the deck through the port deck locker. The old mild steel on didnt look too bad till  I hit it with a hammer and all the rust fell off. See the attached photo of the old pipe and my new stainless pipe ready to be glassed in.

Danny

SM 299

Ocean Pearl

<20200624_135045.jpg>

Dennis Campbell
 

Have just completed the same task on Pegasus (Maramu #178). Cut out rusted section leaving 4" (100mm) top and bottom stub ends of original pipe. Replaced damaged section with 3" (75mm) gal pipe with sliding 3 1/2" collars fitting over each stub end to keep new hawes pipe in position. Then glassed over to secure. 

Danny and Yvonne SIMMS
 

Looks good. Mine was too far gone to reuse any of it.

Danny

SM 299

Ocean Pearl

On 24 June 2020 at 17:57 Dennis Campbell <dennis@...> wrote:

Have just completed the same task on Pegasus (Maramu #178). Cut out rusted section leaving 4" (100mm) top and bottom stub ends of original pipe. Replaced damaged section with 3" (75mm) gal pipe with sliding 3 1/2" collars fitting over each stub end to keep new hawes pipe in position. Then glassed over to secure.