|
Deck Shower 4 messages
Hello, Where is the deck shower installed on your SN or SM? On my SN itโs in the port cockpit locker which is sub optimal... Rgds -- Bernd SN 119 / Cascais, Portugal
Hello, Where is the deck shower installed on your SN or SM? On my SN itโs in the port cockpit locker which is sub optimal... Rgds -- Bernd SN 119 / Cascais, Portugal
|
By Bernd Spanner
·
|
|
Searching for outdoor, motion activated 24V LED light for stern arch 11 messages
Hey Amelians, I figure someone has found/installed a motion-activated 24v LED light. We would like to have it there so that when we dinghy back at night and hop on the swim step, the light comes on fo
Hey Amelians, I figure someone has found/installed a motion-activated 24v LED light. We would like to have it there so that when we dinghy back at night and hop on the swim step, the light comes on fo
|
By Scott SV Tengah
·
|
|
[Amel Yacht Owners] Deck light / Steaming light SM2000 9 messages
Alan, Here you go: Series 41 Masthead/Foredeck Light, White Vessels up to 65' (20 m) | 3 NM visibility | 50 Watt foredeck light By: Aqua Signal https://www.fisheriessupply.com/aqua-signal-series-41-ma
Alan, Here you go: Series 41 Masthead/Foredeck Light, White Vessels up to 65' (20 m) | 3 NM visibility | 50 Watt foredeck light By: Aqua Signal https://www.fisheriessupply.com/aqua-signal-series-41-ma
|
By Mark Erdos
·
|
|
Jib sheet traveller - resource for new spiral springs or rubber buffers 8 messages
Dear Amelians, the spiral springs on our Genoa and Staysail Sheet Cars are nearly all broken. Thus a flapping Sail causes heavy banging etc.. Does anybody knows a resource to get this special spiral s
Dear Amelians, the spiral springs on our Genoa and Staysail Sheet Cars are nearly all broken. Thus a flapping Sail causes heavy banging etc.. Does anybody knows a resource to get this special spiral s
|
By Stefan Schaufert
·
|
|
24v Raymarine Linear Drive Clutch Opperation by NAC-3 5 messages
Hello everyone, I have had to replace my Old Raymarine ST7000 + autopiliot computer. I have gone with a NAC-3 B&G- as many of my new instraments are B&G and I want the integration. As such, I have run
Hello everyone, I have had to replace my Old Raymarine ST7000 + autopiliot computer. I have gone with a NAC-3 B&G- as many of my new instraments are B&G and I want the integration. As such, I have run
|
By Chris Doucette
·
|
|
Linear drive installation 12 messages
I thought I would write this post in case someone wanted to install a linear drive in their SM and found it as daunting as I did. I bought a linear drive to install in my SM .I viewed the install, too
I thought I would write this post in case someone wanted to install a linear drive in their SM and found it as daunting as I did. I bought a linear drive to install in my SM .I viewed the install, too
|
By Patrick McAneny
·
|
|
Cockpit locker leak? 4 messages
Hello fellow Amelians, After some heavy rain last night I noticed a fair amount of fresh water accumulating inside our SM cockpit locker. I figured before I climbed inside the locker with a flashlight
Hello fellow Amelians, After some heavy rain last night I noticed a fair amount of fresh water accumulating inside our SM cockpit locker. I figured before I climbed inside the locker with a flashlight
|
By Kevin Schmit
·
|
|
Fresh Water Pump 15 messages
We would like to convert to a diaphragm type fresh water pump. We are looking two options right now. Shurflo Aqua King II 4.0 gpm (55 PSI sealed switch, shutoff at 3.8 bar, ) and Seaflo Series 54 5.0
We would like to convert to a diaphragm type fresh water pump. We are looking two options right now. Shurflo Aqua King II 4.0 gpm (55 PSI sealed switch, shutoff at 3.8 bar, ) and Seaflo Series 54 5.0
|
By Ian Townsend
·
|
|
New Thread on A54 fridge pumps (ATTN: OLIVER Vela Nautica) 67 messages
This is a new thread to continue the overly long thread at: https://amelyachtowners.groups.io/g/main/topic/a54_fridge_circulation_pump/34255404?p=Created,,,20,1,60,0::recentpostdate%2Fsticky,,,20,2,0,
This is a new thread to continue the overly long thread at: https://amelyachtowners.groups.io/g/main/topic/a54_fridge_circulation_pump/34255404?p=Created,,,20,1,60,0::recentpostdate%2Fsticky,,,20,2,0,
|
By Scott SV Tengah
·
|
|
oil-struts opening windows cockpit Am54 4 messages
ref AM54 : Hi all Amaliens, the oil-pressure-struts which open the cocpit windows have lost their oil. Can anybody help me with advice : can they be refurbished and refilled, and can i do this myself
ref AM54 : Hi all Amaliens, the oil-pressure-struts which open the cocpit windows have lost their oil. Can anybody help me with advice : can they be refurbished and refilled, and can i do this myself
|
By Jeroen Jeltes
·
|
|
Event: Inside Tips - "How to work with a broker to Buy or Sell your Amel" - ZOOM also simulcast and recorded on YouTube - Saturday, 10 April 2021
#cal-invite
Inside Tips - "How to work with a broker to Buy or Sell your Amel" - ZOOM also simulcast and recorded on YouTube When: Saturday, 10 April 2021 20:00 to 21:00 (UTC+00:00) Etc/GMT Where: Internet Worldw
Inside Tips - "How to work with a broker to Buy or Sell your Amel" - ZOOM also simulcast and recorded on YouTube When: Saturday, 10 April 2021 20:00 to 21:00 (UTC+00:00) Etc/GMT Where: Internet Worldw
|
By
main@AmelYachtOwners.groups.io Calendar
·
|
|
New engine install photos 2 messages
Hi Marc, Here are some photos. Fair Winds Eric Kimberlite Amel Super Maramu #376 From: main@AmelYachtOwners.groups.io On Behalf Of eric freedman Sent: Wednesday, March 17, 2021 3:58 PM To: main@AmelYa
Hi Marc, Here are some photos. Fair Winds Eric Kimberlite Amel Super Maramu #376 From: main@AmelYachtOwners.groups.io On Behalf Of eric freedman Sent: Wednesday, March 17, 2021 3:58 PM To: main@AmelYa
|
By eric freedman
·
|
|
Bonding and Solar Power System 8 messages
This post is a continuation of the recent discussion about the rudder post and galvanic protection system. I have discovered that the two green wires that had been disconnected from Flora's bonding sy
This post is a continuation of the recent discussion about the rudder post and galvanic protection system. I have discovered that the two green wires that had been disconnected from Flora's bonding sy
|
By Adam Body
·
|
|
Mounting of the 175 amp alternator on a Yanmar 7 messages
I just finished installing a new Yanmar in Kimberlite. However I forgot to note how the spacers were for the feet of the big alternator in the photo above. Would someone please send me a photo from th
I just finished installing a new Yanmar in Kimberlite. However I forgot to note how the spacers were for the feet of the big alternator in the photo above. Would someone please send me a photo from th
|
By eric freedman
·
|
|
Washing machine Amel 54, how to remove 2 messages
Dear Amelians The Bosch Washing machine on WASABI is dripping the fuse and I want to remove or replace it. I tried to pull it out but something is holding it at the back where I have no access. I sear
Dear Amelians The Bosch Washing machine on WASABI is dripping the fuse and I want to remove or replace it. I tried to pull it out but something is holding it at the back where I have no access. I sear
|
By Rudolf Waldispuehl
·
|
|
Electronic technician to Repair Onan PCBs 9 messages
Wanted for all Amel Owners: Board-level PCB electronics technician to diagnose and repair Onan Printed Circuit Board, Control (PCB). As some of you know, the company that designed and manufactured Ona
Wanted for all Amel Owners: Board-level PCB electronics technician to diagnose and repair Onan Printed Circuit Board, Control (PCB). As some of you know, the company that designed and manufactured Ona
|
By CW Bill Rouse
·
|
|
๐๐ฒ๐ณ๐ฒ๐ฐ๐๐ถ๐๐ฒ ๐ข๐ป๐ฎ๐ป ๐ฃ๐๐ ๐๐ฎ๐ป๐๐ฒ๐ฑ ๐๐ผ ๐ฎ๐๐๐ฒ๐บ๐ฝ๐ ๐ฎ ๐ฟ๐ฒ๐ฝ๐ฎ๐ถ๐ฟ
All, If you have already replaced your defective Onan PCB, I would like to have the defective one. One of our members has the contact information for a guy in Colombia who may be the same guy I met in
All, If you have already replaced your defective Onan PCB, I would like to have the defective one. One of our members has the contact information for a guy in Colombia who may be the same guy I met in
|
By CW Bill Rouse
·
|
|
Looking for a buyers broker. 2 messages
Greetings everyone, My partner Emma and I are looking for a reputable buyerโs broker in Europe, for a Maramu or Santorin. We got in touch with Michel Charpentier but unfortunately he retired. We are b
Greetings everyone, My partner Emma and I are looking for a reputable buyerโs broker in Europe, for a Maramu or Santorin. We got in touch with Michel Charpentier but unfortunately he retired. We are b
|
By Alex BAIZEAU
·
|
|
Main sheet tackle broken catch 8 messages
Dear Amelians, when Olivier did the survey of Borador he noticed the "Main sheet tackle broken catch" was broken. It seems to be a very difficult part to get and Amel does not have it. Can anyone help
Dear Amelians, when Olivier did the survey of Borador he noticed the "Main sheet tackle broken catch" was broken. It seems to be a very difficult part to get and Amel does not have it. Can anyone help
|
By Matti Lohikoski
·
|
|
Housing for Climma Switch assembly 7 messages
Greetings, The switch housing for the Climma Air Conditioning Controls finally broke completely. I have looked online and have not found a reliable source for a replacement. I contacted SAV but they h
Greetings, The switch housing for the Climma Air Conditioning Controls finally broke completely. I have looked online and have not found a reliable source for a replacement. I contacted SAV but they h
|
By Peter de Groot
·
|