It has been a surprise to me how much seaweed and other dirt accumulates in the heat exchanger for the gear box even though there is a strainer at the intake point. Amel recommends that the heat excha

I’m pulling Celtic Cross up on the hard this winter here in Michigan (42 degrees 32 minutes north) and I’d like to know what others have done with their seawater system in freezing climates. I talked

I posted this s few weeks ago with no definitive answers, trying again. I want to replace my deck locker gaskets, and haven’t found a source for them other than Amel. Bill R’s post earlier indicated t

I am ordering these switches on Monday—sorry for the delay. They will be shipped to you express mail. If anyone else is interested, Please email me with the the quantity you wish and your MAILING addr

Hi Kent, Looks like I will order the switches Monday. Please send me your mailing address. Fair Winds Eric From: main@AmelYachtOwners.groups.io [mailto:main@AmelYachtOwners.groups.io] On Behalf Of kar

Hi all, Our bow thruster was gently losing oil. Though we rarely use it, as we like to anchor everywhere, it is 20 years old and I suspect that there is a shallow groove where the seal sits on the sha

Hello there. So I am.looking to change my fuel filters (routine service) and I have no idea what the original Amel fuel system used for this filter. I have already changed the one on the engine but no

Hello all. I need to replace the cheek block on my Mango. Does anyone know who the original manufacturwr or modelnof these blocks are ? Also any recommendations? Schaefer, Harken, garhauler, ronstan a

Hi All, Some time back I wrote that the base of one of our WCs ( Jabsco 37255 )was starting to crack. Unfortunately, the replacement base ( Part no.37004-1000 ) has its anchoring holes in different pl

Has anyone tried this Seaflo air con circulating pump? It is the magnetic type, so no risk of leaks. My existing one is a big beast and still works but a bit fragile now. According to the labels on th

Hi all, We just had our raymarine linear autopilot with the sg3 ast computer fail after working flawlessly for our entire ownership. The error on the head unit raymarine st7002 says "Drive stopped". T

Hello fellow Amelians, Having an issue with the genset on SM2000. After no use for 3 months, it would crank but not start. After 8 sec preheat, pressing START, engine cranks fine, but no ignition. Vis

It s an oil leak from the bottom of the gear box. I found some informations how to fix it. But I can t take the gear box out of the mast... Help!!! Thank you all of you, Philippe

Hello all I have a question that i am struggling with and wondered if the amel hive mind could shed some light. I recently disconnected all batteries and solar I then reconnected and seem to have lost

Just changed bearings and cogwheels on my SM bow-thurster when at anchor. Made a video of the process. Might be of interest for others in need to repair. Do not claim this is the way to do it, just th

Dear Friends; I want to change my standing rigging of my SM#76. She about 28 years old and haven’t changed yet - unfortunately. Do you have any recommendations for me? Can you please share the parts l

I get the attraction of Cromox; No rust Stacks nicely, Clean the 10mm chain has a MBL of 10197 Kg, so strong too BUT one hundred meters would cost about £6115 (Jimmy Greene) including VAT but not deli

My top furling device for the genoa is turning very very badly. I need help to get it going or to dismantle it. I have already taken away the brown tigthening ring and now I can see a white plastic be

Zoom meeting - QSails owner/manager will present sails for Amels When: Saturday, 12 September 2020 20:00 to 21:00 (GMT+00:00) UTC Description: Time will be 2000 UTC. Over 60 Amel owners have purchased

Hi! Bill Kinney & I have been doing some work with new owners of an Amel 54. The outhaul is really stuck. Is there anyone in the group near Annapolis with a pulled for the outhaul that we could borrow