I have a Super Maramu from 1995 OO30017SM141. The mainsail furling gearbox apparently failed and needs replacement. The desision to remove the unit was made by my maintenance guy since I am on the wes

Does anyone have a source for the 680 ohm wire wound potentiometer that dims the light in the compass? After multiple internet several internet searches and two purchases, I can’t find a good match. T

Bill Reynolds CloudStreet SM2K 331

ZOOM Meeting Marine Insurance presentation Questions & Answers When: Saturday, 6 June 2020 20:00 to 21:00 (UTC+00:00) UTC An RSVP is requested. Click here to RSVP Description: I asked Gary Golden, the

Go to YouTube Live stream: https://youtu.be/ufad3J8J-go Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550 www.AmelOwnersYachtSchool.co

ZOOM Meeting Marine Insurance presentation Questions & Answers When: Saturday, 6 June 2020 20:00 to 21:00 (GMT+00:00) UTC Description: I asked Gary Golden, the number 1 person I respect in the insuran

Reminder: ZOOM Meeting Marine Insurance presentation Questions & Answers When: Saturday, 6 June 2020, 20:00 to 21:00, (GMT+00:00) UTC An RSVP is requested. Click here to RSVP Description: I asked Gary

Reminder: ZOOM Meeting Marine Insurance presentation Questions & Answers When: Saturday, 6 June 2020, 20:00 to 21:00, (GMT+00:00) UTC An RSVP is requested. Click here to RSVP Description: I asked Gary

Hello, I realized that one of my poles has a crack of about 5 cm or 2 inches. Anyone here with knowledge of metallurgy regarding advise if and how to fix it or better get a new alloy tube? Not sure ho

Hi all, I just opened my water heater to check the zinc. It's been a few years since I've done this. I found the zinc mostly intact, but covered with a greenish film. The water is a little discolored

My Onan is totally dead nothing happened when trying to star not a slightest click. I have measured 12,8 volt between +on the starter and minus on the alternator, but only about 4 volt between + on th

Hello fello Amelians I've been replacing the bilge bonding strap on our Maramu #162 The job has offered a jolly time well spent sprawled across my engine. Whilst relaxing in this position i _think_ i

Hello all. I have a 1985 Mango and looking at flying dual headsails for downwind running. I have figured out the Amel poles and wanted to know if there was originally a mouse that runs up the foil whe

I need to replace the Amel logo stickers does any one have a J peg file I can send to a vinyl shop to get cut? Thanks.

Hi Amelians, It's my first time to change the anodes in my SM. I couldn't find the specification on Amel manual. Any suggestion? -- Jose Prieto SV Wayag, SM 323 Currently Alicante, Spain

Hi all, on our last passage I popped the breaker on the mainsail Outhaul a couple times. I disconnected the motor from the Outhaul and was able to reset the breaker and actuate the motor, but the when

We will haul Wednesday for an out of water survey. Then back to Island Water World marina for provisions etc. I hope to leave Thursday 2 PM bridge for St Thomas to pick up my crew Then straight back t

Dear Ameliens, I got a new front furler and have to hoist the genoa again. When I prepaired the genoa loops I got the feeling that the Swivel respectively the lower part is in the wrong position. At l

I would like to purchase a copper strap to replace the original bonding strap. I looked in the files but could not find the original size used by Amel. Could someone provide me the width ,thickness an

Hello, Warning according to an incident yesterday in le Marin, Martinique. We observed an AMEL super maramu full sail up entering the bay. The captain left a green buoy at his starboard side and ended