Hi everybody the mizzen traveller rubbers are in need of changing. I have looked but could not find a source where to buy them. Has anybody been more lucky? kind regards and fair winds Robin Amel 54 #

Greetings All, Today, needing to get below the aft cabin mattress we found the mat shown in the pictures. I know we have them under all of the mattresses and I am assuming it is some form of moisture

Dear Community, The other day as the wind was picking up and it was night, I wanted to reef my genoa in a bit. I realized the electric furler was turning but not driving the foil. All the assembly scr

I'm working on a lithium conversion and trying to size an inverter Does anyone know the wattage tha the 3 AC units pull when operating in a 2004 Super Maramu? I am aware that there are startup surges

Quick question for the 54 owners with Boxtron E14. I am getting a thermal protection alarm from the furlers for my genoa, using the Bamar MEJ 1.02 originals. This is occurring after no activity and on

Just a short notice: Lady Charlyette is available from the end of 2023, at the most beautiful spot of the world! Find more informations in the yachtforsale group.

I note that my port primary winch runs at low gear/speed whereas the starboard runs at high speed. I would rather both run in low gear when using the electric motor. Manually turning the winch handle

Hi all, I need to replace the wind sensor cable from the top of the main-mast to the junction box above the bulkhead door. Any advice from anyone who has done this on a 54 would be appreciated? I'll u

Is there an Amel hull loss database somewhere? I've been listening to some of the debate online about bolt-on vs integrated keels. What's missing seems to be a discussion of what actually sinks yachts

A54 and later model Amels, You may be aware of the recent fire and sinking of A54, SV Vagamonda. I believe that I know the origin of the fire because of some things I have seen on various A54's owned

Bill I think you sent this to the wrong person! Cheers Tim

Hi All, I am thrilled to post that I am now the proud owner/caretaker of S/V Joy (SM #388). Since she was built in 2002, she has been lovingly cared for by 4 previous owners under the names Joy, Bambo

The wind speed readout on my B&G 3000 system has not been working since we launched this season. I finally had an opportunity this morning to investigate. I confirmed the processor is working and the

Hi all, This morning my primary windlass motor refused to operate at full speed when retrieving the anchor. It operates, but runs rather slowly, even with no mechanical load to speak of its drawing ar

Hi folks, I’m having machine shop to make me a wrench for ruder nut out of aluminum. Picture attached. If you want I can give you his name and he can do it and ship to you. Also he recently did foil r

Hi everybody, has anybody an idea how to straighten the railing? Best regards, Martin

Hi all, for your interest. Following on from my blockage caused by a kinked pipe I decided, even though there was no blockage, after 14 years or so it was time to clean the circuit. I rigged a circula

Dear Amelians, We have stepped down our masts this winter to accomodate a full bottom job during indoor storage , During stepp down we marked the positions of the spreaders on the shrouds. However we

**Resending this information as it's more appropriate as a new topic** All, I own SM#23, 1990. I've learned a lot about the two different C-drives during my ownership. This knowledge comes from Amel,

I have a tiny pinhole leak in my Onan 11kw genset and am looking for a replacement elbow part # 155-3261-02. Quite frustrating as we barely use ours and flush with fresh water during periods of non-us