The wind speed readout on my B&G 3000 system has not been working since we launched this season. I finally had an opportunity this morning to investigate. I confirmed the processor is working and the

Hi all, This morning my primary windlass motor refused to operate at full speed when retrieving the anchor. It operates, but runs rather slowly, even with no mechanical load to speak of its drawing ar

Hi folks, I’m having machine shop to make me a wrench for ruder nut out of aluminum. Picture attached. If you want I can give you his name and he can do it and ship to you. Also he recently did foil r

Hi everybody, has anybody an idea how to straighten the railing? Best regards, Martin

Hi all, for your interest. Following on from my blockage caused by a kinked pipe I decided, even though there was no blockage, after 14 years or so it was time to clean the circuit. I rigged a circula

Dear Amelians, We have stepped down our masts this winter to accomodate a full bottom job during indoor storage , During stepp down we marked the positions of the spreaders on the shrouds. However we

**Resending this information as it's more appropriate as a new topic** All, I own SM#23, 1990. I've learned a lot about the two different C-drives during my ownership. This knowledge comes from Amel,

I have a tiny pinhole leak in my Onan 11kw genset and am looking for a replacement elbow part # 155-3261-02. Quite frustrating as we barely use ours and flush with fresh water during periods of non-us

Almost 6 years since Nikimat (SM2K #289) was destroyed during Hurricane Irma in Sint Maarten. Less and less I read the forum questions, even less frequently I reply - as I am leaving the island, the t

The engine stop switch for my Perkins M60 does not work. Through trouble shooting I believe the problem is the Fuel Stop Controle Solenoid. In trying to buy a replacement Solenoid am asked if I want a

The following SMs are all the same SM. And, this is what the C-Drive and Propeller (shaft) look like on the above SMs: And someone looking to buy this SM was told by the owner that "Amel Super Maramus

Hi All, I am looking for a little help from you kind bunch of people, please. The items in question are the push button latches fitted to almost all the doors and drawers inside the interior of (at le

Can i make somebody happy with 2 perkins gaskets?

Good day Amelians, Recently, I had someone remove my electric bilge pump for repairs and it now works. My problem is the person who removed it won’t reinstall it. So i will have to do it myself. would

During the post in case of LiFePO and the needed power for the BT I got the understanding that it is a need to move the battery bank from the engine room to the bunk. I tried to see what other has don

Last season, our original brake system was no longer stopping the shaft and prop from turning when sailing above 4 knots. We put in place a temporary solution so we could finish up the season. This se

Hi Guys, after buying Pepino (SM#381) over a year ago, I foolishly agreed to extend my working life. Currently planning to sail out of Greece next April to go through Suez Canal to visit Seychelles, M

I’m just in the initial stages of planning for our solar arch. I’m leaning heavily towards the Atlantic Towers Arch vs new fabrication, and trust I can overcome the Toms River l, NJ to Fiji shipping c

Hi Amelians, did anyone changed the Perkins Prima M50 / Volvo MD22 to a Volvo Penta D2-50 or D2-60 on the SN? * what engine model? * what gearbox model? * Any experiences with the repowering? - any le

Hello Sailors i am trying to send wind & speed info from the Hydra 2K to my new Zeus 3S Plotter, via a NMEA 0183 to NMEA 2K converter . If any of you did it , I would be grateful to know which connect