I seem to have misplaced Appendixes 1 through 4 in the A54 Owners Manual. I would like copies of each, but I am in need of Appendix 4, Electrical Drawings. I will appreciate any help. Bill CW Bill Rou

Hi all, We are replacing our cockpit dodger acrylics and want to improve upon the weatherproof seal that was installed on A54 #69. This hull number has an 8mm round seal glued into a groove in the acr

Greetings All! I remember seeing a post recently regarding carpet replacement. The poster gave all dimensions and what brand carpet binder tape. Can you please direct me to the post? I will buy the ta

Ryan, Where are you and the boat located? As you mentioned there are two blowers. The bigger one is a 220 volt blower that works off of the generator. In front of that is a Jabsco blower that works of

Greetings to all, We recently purchased an Amel 54 which is in very good overall condition. Olivier did the survey for us and found out the intake blower was not functioning. I tested the wiring and i

Hi Arno, hi Nick and Amelia’s The replacement of the Acrylic on my A54 Goiot port lite are due to replace. Who did changed them already and where you found the best place to buy? Arno, did you sourced

Hi all, can the group direct me to video/ experiences/ blogs etc on how the Amel fairs in remote/ cold/ high lat areas. I don't mean ice areas such as NW passage...more anywhere good glass boats can g

Did someone knows if the Air conditioning system is working in both modes heat and cool in the 55 ? I think that when I push the button in the kitchen panel in heat mode the led is blinking and nothin

Hello! I'm trying to get the windlass working in my Sharki. As far as i know it's the original. I see in the V Berth there are 3 wires coming from the windlass: brown, teal, yellow/green. They are dis

We have water intrusion at the base of the staysail tang on our A54 #69. See red circled area on attached photo. Water drips down into the bow thruster locker and while it drains out fine, I'd rather

Good morning, I am in phase of deciding for new sails for my SM 2000. I have a brochure of SM2000 where Tri-radial sails are displayed. There is no other info available. Previous owner have put compos

Hello! I'm looking to put a Rocna on my Sharki. Anyone else rocking a Rocna? How big of one could you fit on? Any pictures? Thank you, i apologize for the shortness of sentences, I'm on my phone. /Mal

Dear all, one of my 4 gas springs / Zylinders which holds the windshield in an open position is leaking. See pic. I only found a very expensive source in NL where the parts are only produced on reques

I am seeing a lot of salt crystals (I think) gathering around the initial manifold from the sea chest (see photo). I was thinking of getting a replacement from SOFOMARIN, but they say they only do thi

Nauticool UK is a distributor of pumps, Air Conditioning, and Refrigeration in Europe. Their brands include Dometic, Calpeda, Gianneschi, and other brands used by Amel. I have negotiated a 10-20% disc

Hi all, just got new primer and Antifouling made by a professional company. what are these patches below the waterline? Gelcoat? thank you , Martin

Here is a photo of my salt water pump. There is slight rippling (see my wavy line) around the outside surface. Also the metal across the ends of the inlet & outlet has broken (see red circles) & is sh

I agree that using a double-lip seal shouldn't make any difference, but I do not know for sure, and I certainly do not know as much as the original designer. The only reason I wouldn't do it is: That

I'm currently servicing my Lofrans Tigress windlass. There is some distortion to the key that engages with the inner clutch cone of the chain gypsy, while at the same time I'm struggling to remove the

Hi all, Has anyone been able to remove the headsail traveller block (see photos below)? The bolts seem to inaccessible to any normal tool. Cheers, Paul Paul Dowd & Sharon Brown S/Y Ya Fohi, Amel 54 #9